
Contractor Sheet (PDF)
Stocking Distributors
Tintura Project
Gallery
Technical Data Bulletin
Specifications
MSDS
Surface Prep Guide



LITHOCHROME® Tintura™ Stain must be applied full strength without thinning. The coverage will vary depending on the method of application, the porosity and texture of the surface, and the appearance desired.
One, two, or three coats may be required to produce the desired color effect and intensity on colored or uncolored concrete and cementitious toppings. The recommended coverage rate is 1000-1200 square feet per gallon (25-30 square meters per liter) per coat.
|
 |
Custom-matched colors are also available.
Examples shown represent three coats of LITHOCHROME® Tintura™ water-based stain applied over uncolored, medium gray concrete, then sealed with two coats of SCOFIELD® Selectseal-W. The concrete color effects produced may differ significantly from that shown on the color chart. A representative test section should be prepared for each individual concrete surface prior to general application.
Please note: concrete colors shown are approximate. Due to shade variations associated with individual color monitors and printers, we suggest utilization of our literature request form to review an actual LITHOCHROME® Tintura™ Color Chart. We strongly recommend that a concrete test slab be poured and approved prior to starting the job. Concrete test slabs should be poured replicating jobsite conditions. |